Provisions the documents cite: formwork, reinforcement (cover, laps, fixing), concreting, curing, geometrical tolerances, inspection classes
What it requires
The execution standard for concrete structures: what is inspected before, during and after a pour and the tolerance classes for the finished work.
How this entry is kept current
- Citation status: carried from drafting; a source check is in the monthly scan queue.
- Watched by: BSI product record check each scan.
- Automated scan: no public page to watch; checked by hand in the monthly review.
Every source is re-checked monthly and the result is published in the scan log. A change that alters what a document should say raises a revision, and past buyers of that document are told.
The 32 documents that cite it
Every KubitDocs document prints its statutory basis on the form itself, so the person signing can verify the citation rather than take our word for it.
Concrete and formwork quality checklists
- Curing and Protection — Quality Inspection Checklist
- Formwork — Line, Level, Ties and Release Agent — Quality Inspection Checklist
- Post-Tensioning and Stressing — Quality Inspection Checklist
- Pour Card — Mix, Slump, Cubes, Placing and Vibration — Quality Inspection Checklist
- Reinforcement — Cover, Laps, Spacers and Cast-Ins — Quality Inspection Checklist
- Striking and Finished Surface — Quality Inspection Checklist
Groundworks and civils quality checklists
- Backfill and Compaction — Quality Inspection Checklist
- Below-Ground Drainage — Quality Inspection Checklist
- Below-Ground Services and Ducts — Quality Inspection Checklist
- Drainage Testing and CCTV — Quality Inspection Checklist
- Excavation and Formation — Quality Inspection Checklist
- Foundations — Trench and Pad — Quality Inspection Checklist
- Ground Gas and Radon Protection — Membrane, Venting and Verification — Quality Inspection Checklist
- Ground-Floor Slab and DPM — Quality Inspection Checklist
- Interceptors, Separators, Pumping Stations and Below-Ground Tanks — Quality Inspection Checklist
- Manholes and Inspection Chambers — Bases, Benching, Rings, Steps and Covers — Quality Inspection Checklist
- Setting Out and Levels — Quality Inspection Checklist
- SuDS — Attenuation Tanks, Crates, Soakaways and Permeable Sub-Base — Quality Inspection Checklist
Inspection and test plans
- Inspection and Test Plan — Concrete and Formwork
- Inspection and Test Plan — Precast, Timber Frame and MMC
- Inspection and Test Plan — Steel Fixing
Piling and substructure quality checklists
- Pile Caps and Ground Beams — Quality Inspection Checklist
- Pile Cut-Off and Integrity Testing — Quality Inspection Checklist
- Pile Installation Record — Quality Inspection Checklist
- Pile Setting Out and Working Platform — Quality Inspection Checklist
- Underpinning — Quality Inspection Checklist
Precast, timber frame and MMC quality checklists
- Precast Delivery, Bearings and Fixings — Quality Inspection Checklist
- SIPs and CLT Panels — Quality Inspection Checklist
- Timber Frame Erection — Sole Plates, Holding-Down and Breather Membrane — Quality Inspection Checklist
- Volumetric Modules and Pod Placement — Quality Inspection Checklist