Provisions the documents cite: whole standard — selection, installation, site testing and records for post-installed anchors
What it requires
The practice for installing resin and mechanical anchors: hole preparation and cleaning, embedment, cure before load, and site proof testing where specified, with the records that show it.
How this entry is kept current
- Citation status: carried from drafting; a source check is in the monthly scan queue.
- Watched by: check for amendment, withdrawal or a new edition at each monthly horizon scan.
- Automated scan: no public page to watch; checked by hand in the monthly review.
Every source is re-checked monthly and the result is published in the scan log. A change that alters what a document should say raises a revision, and past buyers of that document are told.
The 25 documents that cite it
Every KubitDocs document prints its statutory basis on the form itself, so the person signing can verify the citation rather than take our word for it.
Balustrade quality checklists
Cladding & Facades topic RAMS
Cladding and façades quality checklists
- Built-Up and Composite Metal Cladding — Liner, Spacer, Insulation, Outer Sheet and Fasteners — Quality Inspection Checklist
- Copings, Cappings, Soffits and Louvres — Quality Inspection Checklist
- Curtain Walling and Structural Glazing — Quality Inspection Checklist
- Insulation, Cavity Barriers and Fire-Stopping in the Cavity — Quality Inspection Checklist
- Panel Installation — Rainscreen, Composite and Timber — Quality Inspection Checklist
- SFS Infill Walls and Sheathing Board — Frame, Fixings and Sheathing Before the Membrane — Quality Inspection Checklist
- Sealing, Interfaces and Water Testing — Quality Inspection Checklist
- Setting Out, Brackets and Rails — Quality Inspection Checklist
- Unitised Curtain Walling — Units, Hooking-On, Stack Joints and Closure — Quality Inspection Checklist
Concrete cutting and repair quality checklists
- Concrete Repair — Break-Out, Reinforcement, Mortar and Cure — Quality Inspection Checklist
- Resin Anchors and Post-Installed Fixings — Quality Inspection Checklist
- Structural Approval and Scanning Before Cutting — Quality Inspection Checklist
Glazing & Windows topic RAMS
Inspection and test plans
Mechanical, Plumbing & HVAC topic RAMS
Scaffolding & Access topic RAMS
Site inspection records
Structural steel and metalwork quality checklists
- Erection — Alignment, Plumb and Bolting — Quality Inspection Checklist
- Fabrication Release and Delivery — Quality Inspection Checklist
- Holding-Down Bolts and Base Grouting — Quality Inspection Checklist
- Metal Decking and Shear Studs — Quality Inspection Checklist
- Secondary Steel — Lintels, Stairs and Mezzanines — Quality Inspection Checklist
- Site Welding — Quality Inspection Checklist